Shandong customer's products exploded after grinding with sandpaper
Release time:
2024-06-14 00:00
Source:
1.1 Customer name: a customer in Shandong
1.1.1 Problem description: The product bursts after sanding with sandpaper.
Problem troubleshooting: The inspection found that the product explosion location was at the end of the product, there was a stress meter to detect the product, and the explosion was mesh-like.
Problem solving: increase molybdenum ridge in the forehearth, punch and discharge slag at the bottom of the forehearth, and increase the combustion system in the annealing kiln.
Previous Page
Related News
Structural reinforcement and design recommendations for the breast wall Problems in the design and reinforcement of the breast wall structure. It is recommended to consider tiling and supporting structures in the design to avoid voids and deformations. At the same time, on-site construction can also be carried out according to the actual situation, and various materials and methods can be used for reinforcement. In addition, the problem that the exposed steel bricks in the oven process are not affixed with thermal insulation paper leads to serious explosions, which reminds everyone to pay attention to this problem and avoid similar situations.
On-site treatment of cover brick tilting problem and problem analysis
Measures to deal with the problem of tilting of cover bricks The top wire of the cover of an electric furnace built by our company is movable and can be twisted by hand. The reason is that the open-hearth furnace is not adjusted in time when it is kept warm and resumed production, which causes the lower pool wall or the top wire of the pool wall to shrink and the gap to become larger when the furnace is stopped. When the temperature rises, the gap becomes larger, and the bricks will go outward, causing them to sink. In order to solve this problem, a wire position can be welded between the supporting plate and the column to make the supporting plate fixed. In addition, the lack of power of the flowing fans, resulting in large temperature differences, may also be one of the reasons. Finally, the cover bricks and the fused bricks between the over-layer are not reinforced and also need to be strengthened.
How to ensure product stability in the selection of raw materials
1. When controlling the moisture of granularity-sensitive raw materials such as calcite white jade, in addition to conventional drying and drying treatment, microwave drying technology can be used to achieve efficient and accurate dehydration. Microwaves can penetrate the inside of the material, causing water molecules to generate high-frequency vibration friction and heat generation, which is 3-5 times more efficient and more evenly distributed than traditional hot air drying. At the same time, the near-infrared spectrometer is used to monitor the moisture content of raw materials in real time, and when the detected value deviates from the set range, the operating parameters of the drying equipment are automatically adjusted to form a closed-loop control system to ensure that the moisture content of raw materials is stable in the process requirement range.
Precautions for electrical accessories replacement and protective measures
Regarding the replacement and protection measures of electrical accessories, the precautions are divided into the following points.
Glass furnace: how to improve the service life of glass electric melting furnace
With the development of industrial technical glass, the life of glass electric melting furnace has also been extended, and the quality of glass has been significantly improved, which is related to the emergence of refractory materials, new species of refractory materials. In particular, it is closely related to the development of fused refractories in the last century. Due to the high density, wear resistance, good high temperature mechanical properties and corrosion resistance of glass electric melting furnace electric refractory material.
High temperature resistance of glass electric melting furnace
The glass processing industry in our country belongs to the unpopular industry, engaged in very few people, but our country's annual demand for glass is indeed the world's first, such a large demand-supply ratio has not led to a large number of practitioners to switch, what is the reason for this? I think it may be for professional glass furnace technology does not understand it. Many people have never been involved in this field, and their technical understanding is not much, so this is the main factor in the current shortage of talents in the glass industry.